Skip to content
Palinoia Diagnostics

Search Palinoia

Browse all test kits

The Palinoia guide

16-in-1 strip · pad 3 of 16

Iron in drinking water.

What pad 3 on your 16-in-1 strip estimates, and what its first two blocks can and cannot show.

IronPad 3 of 16Illustration of the pad position, handle at the top as the bottle chart’s arrow shows. Pads are drawn in each row’s first chart color.

What the kit’s guide says

“Common in groundwater; can cause staining of fixtures and affect taste.”

Palinoia Water Quality Reference Guide · Know your 24 water parameters · Metals & trace elements, 11 of 24

The EPA reference value

The kit’s reference guide lists “Iron” under “EPA Secondary / Aesthetic & Operational Guidelines”: 0.3 mg/L.

The reference guide uses mg/L; the charts use ppm (and ppb for lead). In water, 1 ppm is about 1 mg/L. An EPA value is a reference for comparison, not a verdict on one home reading.

Common sources

The reference guide’s “Common Source” column lists: soil and rock deposits; pipe corrosion.

What the guide notes

In its “Potential Health Effects” column, the reference guide notes: “May stain fixtures and laundry and create a metallic taste.”

This is general background from the printed guide. A home screening result cannot show an effect on health, or rule one out.

On your Palinoia chart

These levels follow the 16-row chart printed on the strip bottle’s label. Values are in ppm (as Fe).

0 ppm (as Fe) (inside the chart’s OK mark)5 ppm (as Fe)10 ppm (as Fe)25 ppm (as Fe)50 ppm (as Fe)100 ppm (as Fe)250 ppm (as Fe)500 ppm (as Fe)

Outlined colors sit on the chart’s green OK bar, which the label calls a “typical comparison range for quick screening.”

The OK bar covers only the 0 block. The next block is 5 ppm, higher than the 0.3 mg/L secondary guideline in the reference guide, so a 0 match does not prove there is no iron.

The 16-row color chart printed on the 16-in-1 strip bottle’s label, with the HOLD STRIP BY THIS HANDLE END bar and its upward arrow at the left
As printed on the bottle label. Screen colors vary; use the label in your kit.

Compare the pad with the bottle chart within 60 seconds of removing the strip, in natural light. On-screen colors are illustrative and should not be used to read a sample.

Reading this pad

Iron is pad 3 of 16, read together with the other fifteen pads, following the bottle label’s directions:

  1. Collect a clean water sample.
  2. Dip the strip in the water for 2 seconds, then remove it.
  3. Hold the strip flat. Do not shake off excess water.
  4. Compare the pads with the chart on the bottle label straight away, with the handle at the top as the label’s arrow shows. Read within 60 seconds, in natural light.

Sources & further reading

Chart levels, OK marks and timing follow the bottle label; descriptions and EPA values follow the kit’s printed reference guide. These tests are for screening only. Confirm concerning results with a certified lab.