Skip to content
Palinoia Diagnostics

Search Palinoia

Browse all test kits

The Palinoia guide

Sulfate strip · one pad

Sulfate in drinking water.

What the single-pad Sulfate strip shows, against three printed blocks.

SulfateOne padIllustration as drawn on the pouch label: pads at the top, level with the chart rows. The label names the rows, not the pads.

What the kit’s guide says

“Naturally occurring or influenced by wastewater, runoff, or mineral deposits.”

Palinoia Water Quality Reference Guide · Know your 24 water parameters · Water balance & general condition, 19 of 24

The EPA reference value

The kit’s reference guide lists “Sulfate” under “EPA Secondary / Aesthetic & Operational Guidelines”: 250 mg/L.

The pouch label prints beside the row: “EPA Secondary SMCL: 250 mg/L”

In the key printed on the kit’s record log, SMCL means Secondary Maximum Contaminant Level.

The reference guide uses mg/L; the charts use ppm (and ppb for lead). In water, 1 ppm is about 1 mg/L. An EPA value is a reference for comparison, not a verdict on one home reading.

Common sources

The reference guide’s “Common Source” column lists: natural deposits; fertilizers; wastewater influence.

What the guide notes

In its “Potential Health Effects” column, the reference guide notes: “May create a bitter or salty taste and can have a laxative effect for some people.”

This is general background from the printed guide. A home screening result cannot show an effect on health, or rule one out.

On your Palinoia chart

These levels follow the chart printed on the Sulfate strip pouch label. Values are in ppm.

0 ppm (inside the chart’s OK mark)250 ppm (inside the chart’s OK mark)500 ppm

Outlined colors sit inside the label’s green OK bracket.

The chart has three blocks, 0, 250 and 500 ppm, and its OK bracket covers 0 and 250. The label prints “EPA Secondary SMCL: 250 mg/L” beside the row.

The printed Sulfate strip pouch label, with its directions and color chart
As printed on the pouch label. Screen colors vary; use the label in your kit.

Read the pad after 120 seconds, against the chart on the pouch label. On-screen colors are illustrative and should not be used to read a sample.

Reading this pad

The sulfate strip has a single pad. Its pouch label gives four directions:

  1. Dip the strip into water for 5 seconds and remove it.
  2. Gently shake off excess liquid.
  3. Wait 120 seconds for full color development.
  4. Read the test pad against the square color blocks on the pouch label.

The pouch label prints no latest reading time; read when the development time is up.

Sources & further reading

Chart levels, OK marks and timing follow the pouch label; descriptions and EPA values follow the kit’s printed reference guide. These tests are for screening only. Confirm concerning results with a certified lab.